Range Rover Evoque: Touch screen icons

Connect. Use to send or accept

Connect. Use to send or accept a call and access last 10 dialled numbers.

Disconnect. Use to end or reject

Disconnect. Use to end or reject a call.

No phone connected.

No phone connected.

Phone signal strength indicator.

Phone signal strength indicator.

Phone battery level indicator.

Phone battery level indicator.

Bluetooth. Indicates that a

Bluetooth. Indicates that a Bluetooth® device is connected.

Tick. Indicates that a

Tick. Indicates that a Bluetooth® device is paired.

Voice mail. Press and hold to

Voice mail. Press and hold to dial the stored voicemail number.

Scroll bar arrows. Use to scroll

Scroll bar arrows. Use to scroll up or down lists of detected phones, calls or phonebook entries.

READ NEXT:

 Steering wheel icons

Connect. Press and release to send or accept a call or to access the last 10 dialled list. Press and hold to access the phonebook. Disconnect. Use to end or reject a call. Voice control t

 Call volume

The phone call volume is operated by the audio system’s volume control. If the audio system is in use when a phone call is active, the audio system source is suppressed for the duration of the c

 Digit dial

Once your phone is connected to the vehicle’s system, Digit Dial is the default screen in Phone mode. Using the on-screen keypad, enter the required number and touch the connect icon to send. N

SEE MORE:

 Transfer Case Seal RH GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

 Fender Apron Panel Front Reinforcement

Removal NOTES: The fender apron panel front reinforcement is manufactured from RP220 and mild steel. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front side member and fender a

© 2011-2025 Copyright www.rrevoque.org