Range Rover Evoque manuals

Range Rover Evoque: Changing a road wheel

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Changing a road wheel

Changing a road wheel
Changing a road wheel

1. Temporary spare wheel locking ring.

2. Temporary spare wheel retaining bolt.

3. Tool kit retaining bolt.

4. Jack.

5. Wheel brace.

should be After use, the tool kit should be returned to the under floor storage area and correctly stowed.
The spare wheel is heavy and if handled incorrectly may cause injury.
Use extreme caution when lifting or manoeuvring the wheels.
Always secure the spare wheel, or the removed wheel, in the correct position using the retaining bolt.

Always remove the temporary spare wheel before jacking the vehicle.

Note: Examine the jack occasionally, clean and grease the moving parts, particularly the screw thread, to prevent corrosion.

READ NEXT:

 Removing the temporary spare wheel

Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised. Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism. 1.

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehic

SEE MORE:

 Audio Amplifier Module (AAM)

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle. NOTES: If the control module or a component is susp

 Component Description

DESCRIPTION Engine Control Module (ECM) The ECM is located at the rear of the engine compartment, between the bulkhead and the engine sound insulation. The ECM is located in a plastic molded carrier which in turn is located in a bracket attached to the vehicle structure. The ECM is connected to t

© 2011-2025 Copyright www.rrevoque.org