Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 Fuel Rail

Special Tool(s) 310-198 Installer, Teflon Seal 310-199 Re-shape Tool, Teflon Seal Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. Disconnect the battery ground c

 Evaporative Emissions - GTDi 2.0L Petrol

Evaporative Emissions - Component Location COMPONENT LOCATION ROW Clean air purge 2 hose connection Clean air purge 2 hose Vapor purge 3 hose from purge valve Double check valve Venturi Purge valve Purge hose from charcoal canister Clean air purge hose Clean air purge hose connection with

© 2011-2025 Copyright www.rrevoque.org