Range Rover Evoque: Evaporator Temperature Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Heater Core TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).

3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).

4. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Condenser TD4 2.2L Diesel

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur

 Heater Core and Evaporator Core Housing

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operati

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

SEE MORE:

 Restraints Control Module (RCM)

Removal NOTES: The RCM must be replaced after every time any SRS component has been deployed. Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 2. Disconnect

 Rear View Mirrors

Rear View Mirrors - Component Location NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar. DDM (driver door module) Driver exterior mirror Exterior mirror switches Memory switches Interior mirror (automatic dimming version shown) PDM (passenger door

© 2011-2025 Copyright www.rrevoque.org