Range Rover Evoque: Front Lower Arm

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

2. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

Support weight of vehicle on a jack at the rear hub.

4. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

5. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

 Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

 Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

 Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshaf

SEE MORE:

 Gear shift indicator

The gear shift indicator illuminates briefly at the recommended gear change point (upshift). The shift indicator will not illuminate while Cruise control is active and is not being overridden by pressing the throttle pedal. Note: This warning indicator is only a guide. It remains the respo

 Oil Cooler

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 3. Re

© 2011-2025 Copyright www.rrevoque.org