Range Rover Evoque: Interior lights locations
Interior lights locations
1. Sun visor lamps. Illuminates when the vanity mirror is opened.
2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off.
Note: If you are wearing gloves, it may be necessary to touch the lens to operate the lamps.
3. Front interior lamp. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Move a finger close to (or touch) the lens to switch on and off manually.
Touch the lens for two seconds to deactivate/activate automatic illumination.
4. Glove box lamp. Illuminates when the glove box is opened.
5. Footwell lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked.
6. Rear interior/reading lamps. Illuminates when the doors are unlocked and extinguishes 60 seconds after all doors are closed, when the engine starts or when the vehicle is locked. Press the switch to switch on and off manually. Touch the front courtesy lamp lens for approximately 2 seconds to deactivate/activate automatic illumination of the rear interior lamps.
7. Luggage compartment lamp. Illuminates when the tailgate is opened.
READ NEXT:
Interior lights intensity
While the exterior lamps are turned on,
intensity of interior lights can be adjusted. See
248, CONTROLS, Interior illumination control.
Ambient lighting
The LED ambient lighting can be adjusted for
colour and intensity via the touch screen. The
exterior lamps must be turned on while
changes are being made via the touch screen.
See 104, TOUCH SCREE
SEE MORE:
Water Drain Panel Section
Removal
NOTE: The water drain panel section is manufactured from mild steel.
1. The water drain panel section is replaced in conjunction with:
Rear bumper cover
Tailgate
Quarter panel
Rear lamp mounting panel
2. For additional information relating to this repair procedure please see
the foll
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose or pipe end which is to be
disconnected.
Obtain appropriate blanking plugs or caps before disconn
