Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and replace with the specified wheel and tyre as soon as possible. Do not fit more than one temporary

 Engine Wiring Harness GTDi 2.0L Petrol

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTE: Removal steps in this procedure may contain installation details. 1. Disc

© 2011-2026 Copyright www.rrevoque.org