Range Rover Evoque: Rear View Camera (RVC)
Image Processing Module B
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system).
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.
If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Image Processing Module B, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing Section.
For additional information, refer to: Parking Aid (413-13 Parking Aid, Diagnosis and Testing).
READ NEXT:
Satellite
Digital Audio Radio System Module (SDARS)
Satellite Radio Module (SARM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may als
Audio
Front Control Module (ACM) - Low Line
Audio Front Control Module - Low Line (ACM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a faul
Touch
Screen (TS)
Touch Screen Display (FCDIM)
The table below lists all Diagnostic Trouble Codes (DTCs) that could be
logged in the Multifunction Display Module, for
additional Diagnosis and Testing information refer
SEE MORE:
Voice control operation
Voice control operation
1. Voice button: Press briefly to start a voice
session. A pop up will appear on the touch
screen. Press and hold to cancel a voice
session.
Note: Briefly press the Voice button during
a voice session, to interrupt audible
feedback. Wait for the tone to sound before
Component Description
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High beam
Right turn signal indicator
Left turn signal indicator
High beam position
High beam flash
