Range Rover Evoque: Rear View Mirror
Headlamp Control Module B (HCMB)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer approved diagnostic system).
When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places, and with an up-to-date calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
If DTCs are recorded and, after performing the pinpoint tests a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
Where an 'on demand self-test' is referred to, this can be accessed via the 'DTC Monitor' tab on the manufacturers approved diagnostic system.
The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Headlamp Control Module B, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing Section.
For additional information, refer to: Headlamps (417-01 Exterior Lighting, Diagnosis and Testing) / Headlamp Leveling (417-01 Exterior Lighting, Diagnosis and Testing).
READ NEXT:
Climate
Control Module (HVAC)
Heating Ventilation Air Conditioning Module (HVAC)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fa
Instrument Cluster (IC)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
Parking Aid Module (PAM)
CAUTIONS:
Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does not
guarantee confirmation of a fault, and may also cause additional faults in t
SEE MORE:
Changing the smart key batttery
When the battery needs renewing, there will be
a significant decrease in the effective range and
the message SMART KEY BATTERY LOW will
be displayed in the message centre.
To renew the battery:
1. Slide open the side cover.
2. Remove the emergency key and fit into the
receiver.
3. With the
Recommended towing weights
See 197, WEIGHTS, for details of the Gross
Vehicle Weight (GVW), Gross train weight
(GTW), axle weights and maximum payload.
Europe only:
When towing, the maximum permissible Gross
Vehicle Weight can be increased by a
maximum of 100kg (220lb) provided that the
road speed is limited to 97km/
