Range Rover Evoque: Selecting valet mode

Valet mode allows the vehicle to be driven, e.g., by a parking attendant, but leaves the tailgate locked and restricts use of the touch screen.

This prevents access to telephone numbers, navigation addresses and audio system settings.

From the Home menu, select Valet: Enter a four digit Personal identification Number (PIN) (personally chosen). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

After entering the PIN, you will be prompted to enter the PIN again. Enter the same PIN and touch OK to confirm.

A pop-up screen is displayed, confirming your vehicle is now in Valet mode.

READ NEXT:

 Interior protection

The interior protection feature of the full alarm system may be temporarily disabled via Alarm sensors in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU. Note: If the in

 Battery-backed sounder

In certain markets, a battery backed sounder is fitted. This device will sound if it or the vehicle battery is disconnected while the security system is armed.

 Tilt sensor

The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alar

SEE MORE:

  Touch screen overview

Note: Physical controls are referred to as hard keys. Virtual buttons on the touch screen are referred to as soft keys. Screen options will vary depending on vehicle specification and set-up. Touch screen overview 1. Screen on/off. The first use after switching the ignition on will display

  Using the touch screen

Always run the engine during prolonged use of the touch screen. Failure to do so may discharge the vehicle battery, preventing the engine from starting. Avoid spilling or splashing liquids onto the touch screen. Switching on - Switch on the ignition. - Switch on the touch screen. The mos

© 2011-2026 Copyright www.rrevoque.org - 0.0032