Range Rover Evoque: Speed Control

Range Rover Evoque. Speed Control

Speed Control Actuator

Removal

1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

Installation

1. To install, reverse the removal procedure.

Speed Control Deactivator Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. CAUTION: LH illustration shown, RH is similar.

Range Rover Evoque. Speed Control

2.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

Speed Control Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Make the air bag supplemental restraint system (SRS) safe.

Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).

4. Torque: 1.3 Nm

Range Rover Evoque. Speed Control

5. CAUTION: Take extra care not to damage the edges of the component.

Torque: 2.1 Nm

Range Rover Evoque. Speed Control

6. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Speed Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Climate Control System

 Climate Control System - General Information

Climate Control Lubricants, Fluids, Sealers and Adhesives General Specification Capacities Refrigerant oil adding capacities for replacment parts NOTE: Rotate the A/C compressor shaft at least 6 t

 Climate Control

SEE MORE:

 Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia surround. See 111, AUDIO/VIDEO CONTROLS. Press again to display the dual view Options menu. From h

 Communications Network - Overview, System Operation and Component Description

Overview A number of different types of communication networks are incorporated into the vehicle wiring harnesses for the transmission of commands and information between control modules. The configuration installed on a particular vehicle depends on the model and equipment level. The communicati

© 2011-2026 Copyright www.rrevoque.org