Range Rover Evoque: Switching off the engine
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching off the engine
Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied.
1. Select P for automatic transmission, or neutral for manual transmissions.
Note: If any other gear is selected at switch off, the rotary selector will automatically move to P before retracting into the centre console.
2. Press the START/STOP button.
Note: The park brake will apply automatically if it has not already been applied.
READ NEXT:
Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
SEE MORE:
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation detail
Accessory Drive - GTDi 2.0L Petrol
Torque Specifications
Accessory Drive Belt
Removal
NOTE: Some illustrations may show the engine removed for clarity.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: Make sure to support the vehicle with axle stand
© 2011-2025 Copyright www.rrevoque.org
