Range Rover Evoque: Window reset

If the battery is disconnected or the power supply is interrupted, the windows must be reset.

Once the power supply is restored, reset as follows: 1. Close the window fully.

2. Release the switch, then lift it to the close position and hold for 1 second.

3. Repeat the procedure on each window.

READ NEXT:

 Anti-trap protection

Closing a window or roof blind onto any part of the body can result in serious injury. Before closing a window or the roof blind, ensure that no occupants have any part of their body in a posi

 Resonance with lowered windows

if a resonance or booming sound occurs when a rear window is open, lowering an adjacent front window by approximately 25mm (1 inch) will eliminate the condition.

 Mirrors

SEE MORE:

 Brake System - General Information

Brake System Bleeding CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water. NOTES: Bleeding of the complete brake system must be carried out using Land Rover approved diagnostic equipment. Where only the primary or seconda

 Speed Control

Speed Control Actuator Removal 1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation). Installation 1. To install, reverse the removal procedure. Speed Control Deactivator Switch Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTI

© 2011-2026 Copyright www.rrevoque.org