Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Trailer electrical connection

Connect only approved electrical circuits, which are in good condition, to the trailer socket. The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer. When a trailer electrica

 Beltminder

A front and rear seat Beltminder system warns the driver when the seat belt of an occupied seat is not fastened or is unfastened during a journey. Beltminder A graphic accompanied by a text message in the message centre indicates which seat belts are fastened at the start of a journey and a

© 2011-2025 Copyright www.rrevoque.org