Range Rover Evoque: Daytime running lamps

Daytime running lamps are LED lamps.

With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running.

- The gear selector is out of park (automatic transmission).

- The parking brake is not applied - market dependent.

Unless required or prohibited by law,

Unless required or prohibited by law, daytime running lamps can be disabled or enabled by your Dealer/Authorised Repairer.

READ NEXT:

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only acti

 Auto lamps windscreen wiper detection

If Auto lamps is selected and the windscreen wipers are switched on for 20 seconds or more, the side lamps, tail lamps and headlamps will switch on automatically. When the wipers are switched off,

SEE MORE:

 Torque Converter Seal TD4 2.2L Diesel

Special Tool(s) 307-597 Installer, Torque Converter Seal 307-613 Holding Pins, Torque Converter Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

 Rear Seat Backrest Cover 3-Door

Removal NOTES: This procedure covers the removal and installation of both rear seat backrests and the LH rear seat backrest cover. The RH rear seat backrest cover is similar. All notes and cautions must be followed strictly to avoid any chance of NVH or failure of the rear seat backrests. 5-door

© 2011-2025 Copyright www.rrevoque.org