Range Rover Evoque: Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
2. Torque: 10 Nm
3. Torque: 80 Nm
Installation
1. To install, reverse the removal procedure.
Engine Lower Support Insulator
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. CAUTION: Discard the bolts.
4. CAUTION: Discard the bolt.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Only tighten the bolt finger-tight at this stage.
2. CAUTIONS:
Make sure that new bolts are installed.
Install all the bolts finger tight before final tightening.
Torque:
- Stage 1: 50 Nm
- Stage 2: 180
READ NEXT:
Oil Filter Housing
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essent
Engine - Diagnosis and Testing
Principles of Operation
For a detailed description of the engine system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)
SEE MORE:
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain instal
Powered tailgate operation
1. Press to open the powered tailgate.
2. Press and release to close the powered
tailgate.
After the tailgate has opened to its set height, it
can be manually raised or lowered. If the
tailgate fails to open or close correctly, close it
manually then press the tailgate release switch
again.
