Range Rover Evoque: Front/Rear Door Latch
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1 2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Rear Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Exterior Rear Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1.2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Liftgate Latch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 25 Nm
3. Torque: 25 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always co
Wipers and Washers - Component Location, System Operation and Component
Description
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Le
SEE MORE:
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
Glass, Frames and Mechanisms - Component Location, System
Operation and Component Description
Component Location
COMPONENT LOCATION - DOOR MECHANISMS
Passenger door glass motor
Passenger door module
Rear door glass motor
Rear door module
Rear fuse box
Rear door glass motor
Rear door module
Driver door glass motor
Driver door module
CJB (central junction box)
COMPONENT LOCATION -
