Range Rover Evoque: Fuel Fired Booster Heater AWD
Component Location
COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL
- ATC (automatic temperature control) module
- Fuel Fired Booster Heater (FFBH)
- Auxiliary coolant pump
- Ambient air temperature sensor
- Auxiliary fuel pump
COMPONENT LOCATION - VEHICLES WITH FFBH REMOTE CONTROL
- ATC module
- Fuel Fired Booster Heater (FFBH)
- Auxiliary coolant pump
- Ambient air temperature sensor
- Auxiliary fuel pump
- FFBH Receiver
- FFBH antenna matching unit
Overview
OVERVIEW
NOTE: There is no auxiliary coolant pump fitted if there is no FFBH fitted (from VIN 631090).
The Fuel Fired Booster Heater (FFBH) is rated at 5 kW and compensates for the relatively low coolant temperatures inherent in the diesel engine. The unit is located behind the RH (right-hand) front fender splash shield and heats engine coolant downstream of the heater core.
Operation of the FFBH is controlled by the ATC (automatic temperature control) module via the medium speed CAN (controller area network) bus. The operation of the FFBH is influenced by:
- Ambient air temperature
- Engine coolant temperature.
The FFBH will operate if the ambient air temperature is lower than 5
READ NEXT:
Electric Booster Heater - Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
Fuel Fired Booster Heater FWD
Component
Location
COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL
ATC (automatic temperature control) module
Fuel Fired Booster Heater (FFBH)
Auxiliary coolant pump
Ambient air temper
SEE MORE:
Phonebook
Contacts stored in the memory of a paired
phone can be automatically downloaded to the
vehicle’s phonebook each time the phone is
connected to the system. See 141,
TELEPHONE COMPATIBILITY.
Certain mobile phones store the phonebook in
two different areas, the SIM card and the phone
memory. T
Glass Roof Panel Blind Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. NOTE: The step must be carried out on both sides.
Refer to: A-Pillar Trim Panel (501-05 Interior Trim and
