Range Rover Evoque: Locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Locking wheel nuts
Locking wheel nuts can be removed only by using the special adapter provided in the tool kit.
Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It should be removed and stored in the tool kit as soon as possible.
Note: A code number is stamped onto the underside of the adapter. If a replacement adapter is required, you will be asked to quote this number. Ensure that the number is recorded and kept safe, but should not be kept with the vehicle.
READ NEXT:
Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
SEE MORE:
Torque Converter, Valve Block
TORQUE CONVERTER
Torque converter housing
Lock-up clutch
Turbine
Impeller
Stator
Fluid pump
Input shaft
The torque converter is the coupling element between the engine and the
transmission and is located in the transmission
housing, on the engine side of the transmission. The driven power
Differential Case Vehicles With: M66 6-Speed
Manual Transmission AWD
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installation).
3. Refer
© 2011-2025 Copyright www.rrevoque.org
