Range Rover Evoque manuals

Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

READ NEXT:

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Timing Chain

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Specifications

SEE MORE:

 Automatic Transmission/Transaxle External Controls - Vehicles With: AWF21 6-Speed Automatic Transmission

General Specification Torque Specifications External Controls - Component Location COMPONENT LOCATION Downshift paddle switch Upshift paddle switch Transmission Control Switch (TCS) External Controls - Overview OVERVIEW The external controls comprise a rotary TCS (transmission control switch

 Exterior Trim and Ornamentation

Torque Specifications Rear Quarter Panel Moulding Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Discard the retaining clips. Make sure that the centre part of the clip is fully removed from the outer part of the clip. It is not possible to prevent

© 2011-2025 Copyright www.rrevoque.org