Range Rover Evoque: Rear Door

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2.

Range Rover Evoque. Body Closures

3.

Range Rover Evoque. Body Closures

4.

Range Rover Evoque. Body Closures

5. CAUTION: Make sure the upper and lower hinge bolts are replaced.

Torque:

Torx 25 Nm
Bolt 30 Nm

Range Rover Evoque. Body Closures

6. NOTE: Do not disassemble further if the component is removed for access only.

Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

7. Refer to: Rear Door Window Regulator and Motor (501-11 Glass, Frames and Mechanisms, Removal and Installation).

8. Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).

9. CAUTION: Take extra care not to damage the wiring harnesses.

Range Rover Evoque. Body Closures

10. Torque:

Bolt 35 Nm
Nut 12 Nm

Range Rover Evoque. Body Closures

11. Torque: 1.2 Nm

Range Rover Evoque. Body Closures

12.

Range Rover Evoque. Body Closures

13.

Range Rover Evoque. Body Closures

14. NOTES:

Release the seal from the 7 retaining clips by sliding the seal up.

Use a suitable soap solution to aid installation of the seal to the retaining clips.

Range Rover Evoque. Body Closures

15. NOTE: Make sure the top corner of the trim panel is installed to the locating tang, as indicated.

Range Rover Evoque. Body Closures

16. Torque: 1.2 Nm

Range Rover Evoque. Body Closures

17. Torque: 1.2 Nm

Range Rover Evoque. Body Closures

18.

Range Rover Evoque. Body Closures

19.

Range Rover Evoque. Body Closures

20.

Range Rover Evoque. Body Closures

21.

Range Rover Evoque. Body Closures

Installation

1. To install, reverse the removal procedure.

Interior Trim and Ornamentation

Torque Specifications

Range Rover Evoque. Body Closures

READ NEXT:

 Fuel Filler Door

Removal CAUTION: Make sure to protect the paintwork. 1. Installation 1. Fuel Filler Door Assembly Removal WARNING: Avoid flames, sparks or lighted substances. CAUTION: Extreme cleanliness must be ex

 Body Closures - Component Location, System Operation and Component Description

Component Location Powered Tailgate - Component Location Tailgate module Powered strut Tailgate open button Tailgate close button Latch assembly Powered cinch motor Powered strut OVERVIEW Ta

 Interior Trim and Ornamentation

SEE MORE:

 Coolant antifreeze

Antifreeze is poisonous and can be fatal if swallowed - keep containers sealed and out of the reach of children. If accidental consumption is suspected, seek medical attention immediately. If the fluid comes into contact with the skin or eyes, rinse immediately with plenty of water. The

 Tyre pressure monitoring (TPM) system

The TPM system provides a low pressure warning and does not re-inflate your tyres. Tyre pressures should be checked regularly using an accurate pressure gauge when cold. The TPM system can NOT register damage to a tyre. Regularly check the condition of your tyres, especially if the vehicle

© 2011-2025 Copyright www.rrevoque.org