Range Rover Evoque: Side Air Bag Module
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Front Seat Control Switch (501-10 Seating, Removal and Installation).
4. Refer to: Front Seat (501-10 Seating, Removal and Installation).
5. NOTE: If equipped.
6.
7.
8.
9. NOTE: Release the 2 clips located on the underside of the front seat.
10.
11.
12.
3-door
13.
14.
All vehicles
15.
16.
17.
18. WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
19. WARNING: Make sure that the air bag is correctly installed in to the fabric chute. Failure to follow this instruction may result in incorrect operation of the air bag.
Torque: 7 Nm
20.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Side Air Curtain Module
Removal
CAUTION: Do not allow the side air curtain module to twist. Failure to
follow this instruction may result in damage to
the component.
NOTES:
Removal steps in this procedure may contain instal
Clockspring
Removal
CAUTION: Make sure that the road wheels are in the straight ahead
position.
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: St
Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS)
Principle of Operation
For a detailed description of the supplemental restraints system and
operation, refer to the relevant Description and
Operation section in the workshop manual. REFER to: (501-2
SEE MORE:
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starter motor
Generator
Transmission Control Module (TCM)
Cooling fan control module
Air Conditioning
