Range Rover Evoque: Steering Column Switches

Torque Specifications

Range Rover Evoque. Steering Column Switches

Steering Column Multifunction Switch

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Removal of the windshield wiper switch assembly is identical to this procedure.

1.

Range Rover Evoque. Steering Column Switches

2.

Range Rover Evoque. Steering Column Switches

3.

Range Rover Evoque. Steering Column Switches

4.

Range Rover Evoque. Steering Column Switches

5.

Range Rover Evoque. Steering Column Switches

Installation

1. To install, reverse the removal procedure.

Ignition Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

1.

Range Rover Evoque. Steering Column Switches

2.

Range Rover Evoque. Steering Column Switches

3. CAUTION: LH illustration shown, RH is similar.

NOTE: The step must be carried out on both sides.

Range Rover Evoque. Steering Column Switches

4.

Range Rover Evoque. Steering Column Switches

5. Torque: 6 Nm

Range Rover Evoque. Steering Column Switches

6.

Range Rover Evoque. Steering Column Switches

7. Torque: 1.5 Nm

Range Rover Evoque. Steering Column Switches

8.

Range Rover Evoque. Steering Column Switches

Installation

1. To install, reverse the removal procedure.

Steering Column Lock Module

Removal

NOTES:

Removal steps in this procedure may contain installation details.

The steering column lock module is retained with 2 patch locked, tamper proof bolts.

1. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).

2. Using a suitable stud extraction tool, remove the tamper proof bolts.

Range Rover Evoque. Steering Column Switches

Installation

1. CAUTION: Tighten the new tamper proof bolts until the hexagon shears. To install, reverse the removal procedure.

2. Using the Land Rover approved diagnostic system, calibrate a new module.

3. If a new component is installed, the soft lock stop reset routine should be completed on the power steering system, using the approved diagnostic tool.

READ NEXT:

 Engine

 Engine System - General Information

Cylinder Head Gasket Selection TD4 2.2L Diesel Special Tool(s) 303-979 Measuring Bridge, Piston Protusion 1. CAUTION: Make sure that the surface is clean and free of foreign material. Zero the gauge o

 Engine - GTDi 2.0L Petrol

SEE MORE:

 Stalled adjustment

If seat movement stops unexpectedly during adjustment check for any obstructions and remove. Once any obstructions have been removed the seat adjustment mechanism can be reset as follows. Operate the button again to continue the stalled adjustment. When seat movement resumes hold the butt

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd or reverse gears. Automatic transmission: HDC can be used in D, R and CommandShift 1, 2 or 3. Note

© 2011-2025 Copyright www.rrevoque.org