Range Rover Evoque: Transmission Control Module (TCM) TD4 2.2L Diesel
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Automatic Transmission & Transaxle / Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic
Transmission / Transmission Control Module (TCM) TD4 2.2L
Diesel
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Air Cleaner (303-12, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
Installation
1. Torque: 25 Nm
2.
3. Torque:
- M10 47 Nm
- M8 24 Nm
4. CAUTION: Make sure that new components are installed.
NOTE: Do not fully tighten the clamp at this stage.
5. Torque: 10 Nm
6. Torque: 10 Nm
7. Refer to: Air Cleaner (303-12, Removal and Installation).
8. Reconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
9.
- Using the diagnostic tool, calibrate the transmission control module (TCM).
- Using the diagnostic tool, re-calibrate the gear shift module (GSM).
READ NEXT:
Torque Converter Seal TD4 2.2L Diesel
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always co
Transmission Fluid Pan TD4 2.2L Diesel
Removal
CAUTION: Extreme cleanliness must be exercised when handling this
component.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING
Transmission TD4 2.2L Diesel - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the
SEE MORE:
Adaptive dynamics
The adaptive dynamics continuously monitor
road and driver inputs. It detects rough road
and off road conditions, optimises the vehicle
suspension settings to suit each surface type
and adjusts control for greater ride comfort.
Adaptive dynamics is also linked to Terrain
Response Dynamic progr
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is serviced not fully spot welded.
1. In this procedure, to make sure the vehicle is correctly aligned,
© 2011-2025 Copyright www.rrevoque.org
