Range Rover Evoque: Tyre pressure monitoring (TPM) system

pressure warning and does not The TPM system provides a low pressure warning and does not re-inflate your tyres. Tyre pressures should be checked regularly using an accurate pressure gauge when cold.
The TPM system can NOT register damage to a tyre. Regularly check the condition of your tyres, especially if the vehicle is driven off-road.

care not to When inflating tyres, take care not to bend or damage the TPM system valves. Always ensure correct alignment of the inflation head to the valve system.

Note: Different types of tyre may affect the performance of the TPM system. Always replace tyres in accordance with recommendations.

1. TPM system external metal lock nut and

1. TPM system external metal lock nut and valve.

2. Non TPM system rubber valve.

The TPM system constantly monitors the tyre pressure in each wheel. Temporary use spare tyres (when fitted) are not monitored.

The tyre pressure warning lamp

The tyre pressure warning lamp illuminates when one or more of the tyres is significantly under-inflated or a non TPM system wheel and tyre is in use.

This will be accompanied by a

This will be accompanied by a graphic and message in the message centre. The graphic and message will indicate which of the TPM system tyres needs attention.

You should stop and check the tyres as soon as possible and inflate them to the recommended pressure. See 212, CHECKING THE TYRE PRESSURES.

READ NEXT:

 Tpm system messages

When a problem is detected, the warning lamp will illuminate or flash. A text message will be displayed. Until the fault is rectified, the warnings will be repeated each time the ignition is switc

 Tyre change

Valve stem seal, washer, nut, valve core and cap should be replaced at every tyre change. Valve stem seal, washer and nut must be replaced if valve retention nut is loosened. Sensor units and n

 Replacement sensor

Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer. A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The v

SEE MORE:

 A-Pillar Outer Panel

Removal NOTES: The A-pillar outer panel is manufactured from mild steel. The fender mounting bracket is serviced on the new panel. The upper and lower butt joint must be MIG brazed due to the location of a boron reinforcement. A new anti tamper VIN indentification decal will be required when rep

 Changing a bulb

If the lighting has just been switched off, give the bulbs time to cool. Handling them when hot may cause personal injury. Always replace bulbs with the correct type and specification. If you are in any doubt contact your Land Rover Dealer/Authorised Repairer for advice. See 199, BULB

© 2011-2025 Copyright www.rrevoque.org