Range Rover Evoque: Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4.
5. CAUTION: Note the position of the component and mark the surrounding area to aid installation.
6. Remove the bushing.
Special Tool(s): LR-121, 204-620-02, 204-620-03
Installation
1. CAUTION: Make sure that the component is installed to the position noted on removal.
2. CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.
Install the bushing.
Special Tool(s): LR-121, 204-620-01, 204-620-02
3. Torque: 270 Nm
4. Torque: 110 Nm
5. Install the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
READ NEXT:
Rear Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspensi
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's i
SEE MORE:
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
3. NOTES:
The step m
System Operation
PRINCIPLES OF OPERATION - PARKING AID
Vehicles Fitted With Automatic Transmission
If reverse ) is the first gear selected after the ignition is switched on,
both the front (if fitted) and rear parking aid
sensors will become operational. If a forward drive gear is subsequently
selected, the front
