Range Rover Evoque: Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES: Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5.
6.
7.
8. Torque: 10 Nm
9.
10.
11.
12.
13. Special Tool(s): 412-140
14.
15. CAUTION: Make sure that the special tool is correctly located.
NOTE: With assistance remove the component.
Installation
1.
2.
3. To install, reverse the removal procedure.
READ NEXT:
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essenti
Climate Control Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
SEE MORE:
Diesel misfuelling protection device
When the misfuelling device is
activated, it may cause fuel to be
discharged from the filler neck.
Note: It is the driver’s responsibility to fill the
vehicle with the correct fuel. The diesel
misfuelling protection device only reduces the
risk of filling the vehicle with the incorrect fuel
Fuel filler flap
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. If a locking fuel filler flap is fitted, ensure
that the vehicle alarm system is disarmed.
Note: Th
