Range Rover Evoque: Child seat positioning

children are Crash statistics show that children are safest when properly restrained in a child or infant restraint system that is secured in a rear seating position.

table is Information given within the table is correct at the time of going to press.

However, availability of child restraints may change. Please consult your Dealer/Authorised Repairer for the latest recommendation.

Note: The information contained in the following table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/Authorised Repairer.

Note: Ages given are approximate. In case of doubt, the child’s weight not age should be used when considering an appropriate child seat.

Note: The legislation which governs how and where children should be carried when travelling in a vehicle, is subject to change. It is the responsibility of the driver to comply with all regulations in force.

U = Suitable for universal category restraints

U = Suitable for universal category restraints approved for this mass group.

* Always ensure that the passenger airbag has been disabled before using a child restraint in this seating position. See 36, DISABLING THE PASSENGER AIRBAG (not Australia). The seat back needs to be adjusted to the fully upright position.

READ NEXT:

 Recommended child seats

Recommended child seats

 Child restraint check list

Every time a child travels in the vehicle observe the following: - Use appropriate child restraints. - Carefully follow the restraint system manufacturers instructions. - Adjust the harnesses for

 Isofix anchor points (not Australia)

Do not attempt to fit ISOFIX restraints to the centre rear seating position. The anchor bars are not designed to hold an ISOFIX restraint in this position. If the restraint is not correctly a

SEE MORE:

 Side Air Curtain Module

Removal CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component. NOTES: Removal steps in this procedure may contain installation details. RH illustration shown, LH is similar. 1. Disconnect the battery ground cable. Refe

 Back Panel

Removal NOTES: The back panel is manufactured from mild steel, it includes the bumper retaining bracket. It is necessary to remove a section of both rear lamp mounting panels to enable removal and installation of the back panel. 1. The back panel is replaced in conjunction with: Rear bumper cov

© 2011-2025 Copyright www.rrevoque.org