Range Rover Evoque: Engine starting: manual transmission
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting: manual transmission
Note: Do not press the accelerator pedal when starting the engine.
1. A valid Smart Key must be inside the vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.
READ NEXT:
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult
Switching off the engine
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
Switching off the engine with the vehicle moving
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
SEE MORE:
Engine Timing
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed
Manual Transmission AWD
Special Tool(s)
100-012
Slide Hammer
303-1300
Remover, Crankshaft Seal
303-538
Remover/Installer, Crankshaft Oil Seal
307-594
Installer, Seal
307-595
Installer, Intermediate Shaft Seal
308-615
Remover, Seals
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information
© 2011-2025 Copyright www.rrevoque.org
