Range Rover Evoque: Evaporator Temperature Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Heater Core TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).

3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).

4. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Condenser TD4 2.2L Diesel

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur

 Heater Core and Evaporator Core Housing

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operati

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

SEE MORE:

 Fuse box locations

Fuse box locations When a fuse box lid is removed, take care to protect the box from moisture, and refit the lid at the earliest opportunity. Engine compartment - fuse box access: 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. 3. Delatch the tabs. Th

 Winter tyres

In many countries legislation exists that requires the use of winter tyres during specified periods of the year. M+S tyres have a recognised level of winter performance and need not be replaced. When changing to winter tyres, they must be fitted to all four wheels. If the vehicle has TPMS but

© 2011-2025 Copyright www.rrevoque.org