Range Rover Evoque: Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual Transmission/Transaxle External Controls, Removal and Installation).
3. CAUTION: Carefully release the retaining clips.
4.
5. CAUTION: Carefully release the retaining clips.
Vehicles with automatic transmission
6. CAUTION: Carefully release the retaining clips.
7.
All vehicles
8. NOTE: Do not disassemble further if the component is removed for access only.
Torque:
M5 bolt 1.5 Nm
Screw 1.1 Nm
9. Torque: 1.1 Nm
10. Torque: 1.1 Nm
11. Torque: 1.1 Nm
12. Torque: 1.1 Nm
Installation
1. To install, reverse the removal procedure.
2. Connect Land Rover approved diagnostic equipment to vehicle. Read and clear the stored DTCs.
Torque Specifications
READ NEXT:
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Power Flows
Operation of the transmission is controlled by the TCM which electrically
activates various solenoids to control the
transmission gear selection. The sequence of solenoid activation is based on
programmed information in the TCM memory
and physical transmission operating conditions such as vehicle
The navigation system
Navigation instruction is by map and turn
information displayed on the touch screen and
can be complemented by voice guidance if
required. The system uses signals from Global
Positioning System (GPS) satellites combined
with information from vehicle sensors and
from data stored on the hard dri
