Range Rover Evoque: Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these components.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure that all openings are sealed. Use new blanking caps.
1. Remove the rear wheel.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
2.
3.
4.
5.
6.
7. CAUTION: Make sure to protect the paintwork.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1.
2. To install, reverse the removal procedure.
READ NEXT:
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door
A-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
B-Pillar Upper Trim Pane
SEE MORE:
Automatic transmission
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then rotate the drive
selector. The related LED by the selector
will illuminate.
Note: If pressure is
Side Air Curtain Module
Removal
CAUTION: Do not allow the side air curtain module to twist. Failure to
follow this instruction may result in damage to
the component.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, LH is similar.
1. Disconnect the battery ground cable.
Refe
