Range Rover Evoque: hazard warning lamps

Hazard warning lamps
Hazard warning lamps

Press to turn the hazard warning lamps on.

Press again to turn off. When the hazard warning lamps are operating, the direction indicator warning lamps will flash in time with the hazard warning lamps.

Note: Hazard warning lamps can be used when the ignition is on or off.

READ NEXT:

 Interior lights

 Interior lights locations

Interior lights locations 1. Sun visor lamps. Illuminates when the vanity mirror is opened. 2. Map reading lamps. Move a finger close to (or touch) the relevant lens to switch on/off. Note: If

 Interior lights intensity

While the exterior lamps are turned on, intensity of interior lights can be adjusted. See 248, CONTROLS, Interior illumination control.

SEE MORE:

 Transfer Case Seal LH TD4 2.2L Diesel

Special Tool(s) 100-012 Slide Hammer 205-873/1 Remover/Installer, Transfer Case Seal 205-873/2 Protector, Transfer Case Seal 205-873/3 Punch/Screws, Transfer Case Seal Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but

 Dynamic stability control (amber)

Dynamic stability control (amber) Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DSC system. The vehi

© 2011-2025 Copyright www.rrevoque.org