Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Satellite Digital Audio Radio System Module (SDARS)

Satellite Radio Module (SARM)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle  NOTES: If the

 Fender Apron Panel Reinforcement

Removal NOTE: The fender apron panel reinforcement is manufactured from mild steel. 1. 2. For additional information relating to this repair procedure please see the following: For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operat

© 2011-2025 Copyright www.rrevoque.org