Range Rover Evoque: B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.

2.

3.

4. CAUTION: Discard the bolt.
Torque: 45 Nm

5.

6.

Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
D-Pillar Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.

2. NOTE: LH side only.

3.

5-door
4.

3-door
5.

All vehicles
6. Torque: 6 Nm

7.

8.

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Torque: 6 Nm
2. Torque: 6 Nm
3. Torque: 0.9 Nm
4. Torque: 1.3 Nm
5-door
5.
3-door
6.
All vehicles
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
SEE MORE:
Component Location
COMPONENT LOCATION (GTDI)
Refrigerant pressure sensor
Cabin humidity sensor (if fitted)
A/C (air conditioning) compressor
ECT (engine coolant temperature) sensor
Ambient air temperature sensor
Air intake stepper motor
Pollution sensor
Windshield distribution (defrost) st
Locking wheel nuts can be removed only by
using the special adapter provided in the tool
kit.
Note: When the vehicle is first supplied, the
adapter may be stored in the glove
compartment. It should be removed and stored
in the tool kit as soon as possible.
Note: A code number is stamped onto
© 2011-2025 Copyright www.rrevoque.org
