Range Rover Evoque: Battery - Removal and Installation
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Battery and Charging System / Battery, Mounting and Cables / Battery - Removal and Installation
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1.
2.
3. Torque: 25 Nm
4. Torque: 25 Nm
5.
6. Torque: 6 Nm
7. NOTE: If equipped.
Torque: 10 Nm
8.
9. Torque: 6 Nm
10. Torque: 6 Nm
11.
12.
13.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Battery Tray
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Battery
Generator and Regulator - GTDi 2.0L Petrol
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting gener
SEE MORE:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK on automatic transmission selector.
Select 'N' - Neutral on manual transmission.
WARNING: If
the
Rear Quarter Window Glass 3-Door
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: B-Pillar Upper Trim Panel - 3-Door (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and
Ornament
© 2011-2025 Copyright www.rrevoque.org
