Range Rover Evoque: Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.






Side Panel Dimensions
3-door version


5-door version


3-door version


5-door version




Rear End Body Dimensions




Under Body Dimensions




Gap and Profile measurements
The following information is to be used as a guide to assist the technician
in installing exterior body panels and trim items
so as to achieve a correctly aligned and cosmetically acceptable vehicle.
NOTE: All dimensions shown are in millimetres (mm).








READ NEXT:
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment j
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is
SEE MORE:
Please refer to the Ownership section of the
Land Rover website at www.landrover.com,
for a list of compatible phones.
Note: The Bluetooth® equipped phones listed
on Landrover.com, have been tested for
compatibility with Land Rover vehicles.
Performance will vary, based on the phone’s
soft
OVERVIEW
The climate control system incorporates the heating, ventilation and A/C (air
conditioning) systems. There are 2 main
types of climate control system available:
a dual zone automatic system
a dual zone automatic system with cool rear face option.
The climate control functions for both
© 2011-2025 Copyright www.rrevoque.org
