Range Rover Evoque: Blower Motor LHD AWD/LHD FWD

Special Tool(s)

412-140
Remover/Installer, Blower Motor

Removal

NOTES: Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).

4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

7.

Range Rover Evoque. Climate Control

8. Torque: 10 Nm

Range Rover Evoque. Climate Control

9.

Range Rover Evoque. Climate Control

10.

Range Rover Evoque. Climate Control

11.

Range Rover Evoque. Climate Control

12.

Range Rover Evoque. Climate Control

13. Special Tool(s): 412-140

Range Rover Evoque. Climate Control

14.

Range Rover Evoque. Climate Control

15. CAUTION: Make sure that the special tool is correctly located.

NOTE: With assistance remove the component.

Range Rover Evoque. Climate Control

Installation

1.

Range Rover Evoque. Climate Control

2.

Range Rover Evoque. Climate Control

3. To install, reverse the removal procedure.

READ NEXT:

 Blower Motor RHD AWD/RHD FWD, RHD

Special Tool(s) 412-140 Remover/Installer, Blower Motor Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essenti

 Climate Control Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: LH illustration shown, RH is similar. NOTE: The procedure must be carried out on both sides.

 Evaporator LHD

Removal NOTES: The removal of this component involves cutting an aperture in the evaporator housing wall and cutting through the high and low pressure A/C lines. A service repair kit is supplied to c

SEE MORE:

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation). Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron

 Park assist

Park assist is a driving aid only. It remains the driver's responsibility to drive with due care and attention during parking manoeuvres. Park assist may not detect moving objects such as children and animals, until they are dangerously close. Always use extreme caution when manoeuvring.

© 2011-2025 Copyright www.rrevoque.org