Range Rover Evoque: Commandshift™
To return to Sport mode after CommandShift
has been selected, move the selector back to D
then back to Sport mode. Transmission
Commandshift Selected will appear in the
message centre when the transmission is in
CommandShift mode.
Note: In order to protect the engine, the
transmission will automatically change up to
prevent over-revving, or down if the engine is
labouring.
READ NEXT:
Push the accelerator pedal fully down to
achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear
changing will resume.
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
SEE MORE:
The fuel consumption figures shown below have been calculated using a
standard testing
procedure (the new EC test procedure from Directive 99/100/EC), and produced in
accordance with
The Passenger Car Fuel Consumption (Amendment) Order 1996.
Under normal use, a vehicle’s actual fuel consump
Installation
Special Tool(s)
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously
removed.
2. NOTE: This step is only
© 2011-2025 Copyright www.rrevoque.org
