Range Rover Evoque: Conditions preventing automatic engine stop

The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not reached operating temperature
- driver’s seat belt is not fastened
- driver’s door is not fully closed
- the driver’s foot is on either the clutch or accelerator pedals
- climate control system demand is high
- battery charge is low
- the DPF is regenerating
- HDC or a Terrain Response special program are selected

Note: The stop/start system is disabled when a trailer electrical connection is made.

READ NEXT:

 Conditions causing automatic engine restart

The engine will automatically start if:<> - climate control system demand increases - the vehicle’s speed reaches approximately 4km/h (2.5mph) - HDC or a Terrain Response special program ar

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

 Eco stall recovery

In the event that the engine stalls, it can be restarted by fully depressing the clutch pedal. Note: Automatic stall restart will only operate once. If the engine is stalled a second time the engi

SEE MORE:

 Land rover tyre repair kit

Land rover tyre repair kit 1. Maximum speed label. 80 km/h (50 mph). 2. Tyre inflation hose. 3. Inflation hose protective cap. 4. Inflation hose connector. 5. Compressor power cable. 6. Power cable connector. 7. Sealant bottle receiver cap (orange). 8. Sealant bottle receiver. 9. Sealant

 Fender Apron Upper Panel

Removal NOTES: The fender apron upper panel is manufactured from mild steel. The service panel is serviced not fully spot welded. There is an NVH component on this panel, it is serviced on the new panel. 1. The fender apron upper panel is replaced in conjunction with: Front bumper cover Hood H

© 2011-2025 Copyright www.rrevoque.org