Range Rover Evoque: Engine starting

leave it Never start the engine, or leave it running, when the vehicle is in an enclosed space. Exhaust gasses are poisonous and can cause unconsciousness and death if inhaled.

do not If the engine fails to start, do not continue cranking as this will discharge the battery. It may also damage the catalytic convertor due to unburnt fuel passing through the exhaust.

Note: For diesel engined vehicles the delay period before cranking begins will be longer in low ambient temperatures due to extended glow plug operation. During this extended delay the clutch pedal (manual transmissions) or brake pedal (automatic transmissions) must remain depressed.

The diesel engine glow plug

The diesel engine glow plug warning lamp will remain illuminated while the glow plugs are operating.

READ NEXT:

 Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle. 2. Make sure the gear selector is in P or N. 3. Firmly depress the brake pedal. 4. Press and release the start button. The engine will crank autom

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

SEE MORE:

 Oil check preparation

Prior to checking the oil level ensure that: - The vehicle is on level ground. - The engine oil is cold. Note: If it is necessary to check the oil level when the engine is hot, switch off the engine and let the vehicle stand for 5 minutes to allow the oil to drain back into the sump. Do not st

 Wiring Harness - Description and Operation

Introduction CAUTION: Do not use any other heat shrink sleeve other than the approved glue lined heat shrink sleeve mentioned in the repair procedure. The purpose of this document is to promote quick and efficient minor repair to harness connectors or cables using approved methods and the wiring

© 2011-2025 Copyright www.rrevoque.org