Range Rover Evoque: Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
3.
4.
5.
6.
Installation
1. To install, reverse the removal procedure.
Heater Core TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).
3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).
4. CAUTION: Be prepared to collect escaping coolant.
5.
6. CAUTION: Be prepared to collect escaping coolant.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur
Heater Core and Evaporator Core Housing
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operati
Defrost Vent/Register Blend Door Actuator LHD AWD/LHD
FWD
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
SEE MORE:
Component Description
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High beam
Right turn signal indicator
Left turn signal indicator
High beam position
High beam flash
Powered tailgate operation
1. Press to open the powered tailgate.
2. Press and release to close the powered
tailgate.
After the tailgate has opened to its set height, it
can be manually raised or lowered. If the
tailgate fails to open or close correctly, close it
manually then press the tailgate release switch
again.
