Range Rover Evoque: Front Halfshaft RH LHD AWD/RHD AWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will occur.
Make sure the halfshaft constant velocity (CV) joints do not over articulate. Failure to follow this instruction may result in damage to the CV joints.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. CAUTION: Discard the nut.
4.
5. CAUTIONS:
Do not use air tools to remove the nut.
Discard the nut.
6. CAUTION: Discard the bolt.
7.
8.
9. CAUTIONS:
Make sure that the driveshaft is supported with suitable retaining straps.
Do not use a hammer to detach the halfshaft from the hub assembly, failure to follow this instruction may result in damage to the halfshaft. Special Tool(s): 205-857
10.
11. WARNING: Be prepared to collect escaping fluids.
CAUTION: Keep the halfshaft horizontal to avoid damaging the oil seal.
12.
Installation
1. CAUTION: Keep the halfshaft horizontal to avoid damaging the oil seal.
2. CAUTION: LH illustration shown, RH is similar.
3. CAUTION: Make sure that the halfshaft bearing is correctly located in the support bracket before installing the retaining nuts. Torque: 25 Nm
4.
5. Torque: 110 Nm
6. CAUTION: Make sure that a new bolt is installed. Torque: 200 Nm
7. WARNING: Make sure that a new nut is installed.
CAUTIONS:
Do not use air tools to install the nut. Failure to follow this instruction may result in damage to the component.
Install the halfshaft nut finger tight.
Tighten the nut without the weight of the vehicle on the suspension.
Torque:
Stage 1: 120 Nm
Stage 2: 60
READ NEXT:
Inner Constant Velocity (CV) Joint Boot
Special Tool(s)
303-D121
Puller, General Purpose
General Equipment
Vise
Removal
NOTE: RH inner constant velocity joint boot shown, LH is similar.
1. Refer to: Front Halfshaft LH (205-04 Front Drive
Front Halfshaft RH FWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end
SEE MORE:
Audio/video controls
Audio/video controls
There are two levels of infotainment with touch
screen. The full system has the additional
features of Stored CD and DVD, TV/My video
and Rear media. Illustrations show the full
system.
Sustained exposure to high
sound
levels (greater than 85 decibels) can
damage yo
Extra features
There are more features available than can be
displayed at one time. This menu allows the
selected features to be displayed, for example:
- Ambient lighting: While the headlamps are
turned on, select this feature to turn
ambient lighting on or off. Adjust the
lighting level to suit. Adjusting
