Range Rover Evoque: Locking wheel nuts
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Locking wheel nuts
Locking wheel nuts can be removed only by using the special adapter provided in the tool kit.
Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It should be removed and stored in the tool kit as soon as possible.
Note: A code number is stamped onto the underside of the adapter. If a replacement adapter is required, you will be asked to quote this number. Ensure that the number is recorded and kept safe, but should not be kept with the vehicle.
READ NEXT:
Releasing locking wheel nuts
1. Insert the wheel nut adapter into the
locking wheel nut, ensuring that it is fully
engaged.
2. Locate the wheel brace over the adapter
and unscrew the wheel nut half a turn
counter clockwise.
Wheel changing
WARNING - THAT NO PERSON
SHOULD PLACE ANY PORTION OF
THEIR BODY UNDER A VEHICLE THAT
IS SUPPORTED BY A JACK.
Position the jack from the side of the
vehicle, in line with the appropriate
jacking
SEE MORE:
Rear Halfshaft RH
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
Clutch
Lubricants, Fluids, Sealers and Adhesives
General Specification
Torque Specifications
* Tighten bolts progressively by diagonal selection.
Clutch Disc and Pressure Plate Vehicles With: M66 6-Speed Manual
Transmission AWD
Special Tool(s)
303-1272
Locking Tool, Flywheel
308-667
Aligner, Clutch
Remo
© 2011-2025 Copyright www.rrevoque.org
