Range Rover Evoque: Parking aids
Parking aids
1. Parking aid on/off switch. The switch indicator will illuminate.
When reverse gear is selected, the front and rear parking sensors are activated automatically.
To turn off, press the button. The indicator will extinguish.
2. Approximate sensor range -600mm (24in).
3. Approximate sensor range -1500mm (60in).
It remains the driver’s
responsibility
to detect obstacles and estimate the
vehicle’s distance from them. Some
overhanging objects, barriers, chain
link fences, small children, animals,
thin obstructions or painted surfaces
may not be detected by the system.
Systems using the same
frequency
band as the front parking sensors, may
cause irregular tones to be emitted.
Front sensors will remain active as long as the vehicle's speed does not exceed 16km/h (10mph).
With automatic transmission, selecting N from R will keep front and rear sensors active.
When objects are detected, the parking aid emits a warning tone which increases in frequency as the vehicle gets closer to the object and then becomes constant when the obstacle is within 300mm (12in).
Note: The front parking aid provides an audible proximity warning when driving forwards and when reversing.
READ NEXT:
Towing
The rear sensors are automatically disabled
when a trailer with an approved electrical
connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking aids sensors.
Cleaning the sensors
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampo
System fault
If a system fault is detected, a long
high-pitched tone will sound and the switch
indicator will flash. A message will be displayed
in the message centre. Contact your Dealer/
Authorised Repairer
SEE MORE:
Anti-Lock Control
Torque Specifications
Anti-Lock Brake System (ABS) Module
Removal
CAUTIONS:
If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contai
Fuel Charging and Controls - Component Location, System Operation and Component Description
Component Location
COMPONENT LOCATION
Overview
OVERVIEW
The 2.0L GTDi engine is equipped with a high-pressure direct injection system
controlled by the ECM (engine control
module). A high-pressure fuel pump delivers a uniform level of pressure to the
shared fuel rail, which serve all 4 fuel
injec
