Range Rover Evoque: Rear Quarter Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3.
4.
5.
6. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
7.
8. NOTE: Do not disassemble further if the component is removed for access only.
9.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
B-Pillar Upper Trim Panel 3-Door
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
4.
5. Torque: 6 Nm
6.
7. NOTE: 5-door illustration shown, 3-door is similar.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
Interior Trim and Ornamentation
Torque Specifications
READ NEXT:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
Wipers and Washers - Removal and Installation
Windshield Wiper Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and
Installation).
2. NOTE: LHD illustration shown, RHD is similar.
Torque: 8 Nm
Installation
1. To install, reverse the removal proced
Rear Wheelhouse Outer
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
