Range Rover Evoque: Rear seat access (coupe models)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Front seats / Rear seat access (coupe models)
The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.
1. Lift the locking lever and pivot the seatback forwards.
2. Press the front of the switch to power the seat forwards.
3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.
READ NEXT:
Folding and raising the rear seats
Folding and raising the rear seats
The split fold rear seat of 5 door models can be
folded completely, or partially at 60/40 split, to
accommodate loads and still retain seating for
passengers.
Rear seat head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
SEE MORE:
Accessory Drive - GTDi 2.0L Petrol
Torque Specifications
Accessory Drive Belt
Removal
NOTE: Some illustrations may show the engine removed for clarity.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: Make sure to support the vehicle with axle stand
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
3. NOTES:
The step m
© 2011-2025 Copyright www.rrevoque.org
