Range Rover Evoque: Rear wiper
If reverse gear is selected while the front wipers are operating, the rear wiper will start automatically and continue as long as reverse gear is selected. The wipe interval is dependent on the front wipers setting.
If reverse gear is selected while the rear wiper control is in the INT position, the wiper will operate for a single sweep of the rear screen.
When stationary, if the tailgate is opened while the rear wiper is operating, the wiper will stop.
When the tailgate is closed, the wiper will start to operate again after a delay of three seconds.
If the tailgate is open and vehicle speed is above 3km/h (2mph) the wiper will operate normally.
READ NEXT:
Wiper blade replacement
This subject is covered in the Maintenance
section. See 175, WIPER BLADE
REPLACEMENT.
Electric windows and panoramic roof blind
Electric windows and panoramic roof blind
1. Briefly pull a switch fully up and release,
the window will continue to rise until fully
closed. Briefly press a switch fully down
and release, the w
SEE MORE:
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; F = RF transmission; N = Medium speed CAN (controller
area network) bus; O = LIN (local
interconnect network) bus.
Instrument cluster
CJB (central junction box)
Radio frequency (RF) receiver
RFA (remote function actuator) / KVM (keyless vehicle module)
Re
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mounted in the engine compartment. The engine weight is kept
to a minimum by using aluminum for
the cyli
© 2011-2025 Copyright www.rrevoque.org
