Range Rover Evoque: Timing Cover

Special Tool(s)

303-021
Engine support bracket

JLR-303-1591
Lifting Bracket, Engine - Rear

Removal

NOTES:

Some illustrations may show the engine removed for clarity.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Crankshaft Pulley (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

4. Refer to: Valve Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

5.

6.

7.

8.

9.

10.

11. Torque: 45 Nm

12. CAUTION: Protect the paintwork during this operation.

13.

14. NOTE: Loosen the bolt, but do not fully remove.

15.

16.

17.

18. NOTE: Make sure that all traces of the old sealant are removed from the mating faces.

Installation

1. CAUTION: Apply sealant WSE-M4G323-A6 in a 4-7mm diameter on the engine front cover as shown.

The component must be installed and tightened within 10 minutes of sealant application.

2. CAUTION: Tighten the bolts in the sequence shown.

Torque:

• M6 10 Nm
• M10 48 Nm

3. Torque: 80 Nm

4. Torque: 80 Nm

5. Torque: 110 Nm

6. NOTE: Loosen the bolt, but do not fully remove. Torque: 110 Nm

7. CAUTION: Protect the paintwork during this operation. Remove the special tool.

Special Tool(s): 303-021

8. Remove the special tool.

Special Tool(s): JLR-303-1591

9. Torque: 6 Nm

10.

11. Torque: 24 Nm

12. Torque: 20 Nm

13. Torque: 25 Nm

14.

15. Refer to: Valve Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

16. Refer to: Crankshaft Pulley (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).

17. Refer to: Battery (414-01 Battery, Mounting and Cables, Removal and Installation).

READ NEXT: