Range Rover Evoque: To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 seconds), then release
the buttons.
All memories in HomeLink have now been
cleared.
Note: Do not perform this procedure when
programming the additional garage door
opener buttons.
READ NEXT:
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
Instrument panel
1. Speedometer.
2. Driver Information Centre (message centre).
3. Tachometer.
4. Temperature gauge
Serious engine damage can
occur if
the vehicle is driven while the
engin
SEE MORE:
Removal
CAUTIONS:
Make sure that the wiring harness is not twisted or damaged on removal. Failure
to follow this instruction may result
in damage to the vehicle.
Take extra care not to damage the wiring harness clips.
NOTES:
Some variation in the illustrations may occur, but the essential informa
RED warning lamps are for primary warnings.
A primary warning must be investigated
immediately.
Seek qualified assistance before continuing.
AMBER and YELLOW warning lamps are for
secondary warnings. Some indicate that a
vehicle system is in operation, others indicate
that the driver must tak
© 2011-2025 Copyright www.rrevoque.org
